jagman
  • jagman
  • 50.2% (Neutral)
  • Newbie Topic Starter
17 years ago
...replace this line with your message...

Photograph:

πŸ”—Cwmorthin-24-05-2008-Image-012[linkphoto]Cwmorthin-24-05-2008-Image-012[/linkphoto][/link]

Nice pic
Whats over the other side?
Vanoord
17 years ago
I suspect that's down on G is it?

It's probably just the working ledge at the back of the chamber, but I doubt anyone's gone there since the 1930s.

This is, if my memory serves me correctly, one of the chambers that's west of the Ch.34 incline and walled off on DE?
Hello again darkness, my old friend...
jagman
  • jagman
  • 50.2% (Neutral)
  • Newbie Topic Starter
17 years ago
Fancy a look over there sometime in the near future?
simonrl
  • simonrl
  • 51% (Neutral)
  • Administration
17 years ago
"vanoord" wrote:

This is, if my memory serves me correctly, one of the chambers that's west of the Ch.34 incline and walled off on DE?



That's the one; Ch36 G floor
my orders are to sit here and watch the world go by
Vanoord
17 years ago
You can have a look from the top if you pop through the hole by the incline ;)

If you want silliness, I'm sure we can find you some in there...
Hello again darkness, my old friend...
jagman
  • jagman
  • 50.2% (Neutral)
  • Newbie Topic Starter
17 years ago
"Vanoord" wrote:

You can have a look from the top if you pop through the hole by the incline ;)

If you want silliness, I'm sure we can find you some in there...



Feeling much inclined to silliness πŸ˜‰
Also have a hankering to try my hand at building one of those peg and plank walkways around a chamber (although I think wire rope will be a far cheaper alternative to chain for the guide)
We have lots od suitable pegs.....
simonrl
  • simonrl
  • 51% (Neutral)
  • Administration
17 years ago
Sounds fun, shall I bring the drill?

We've got those 20mm drill bits as well...
my orders are to sit here and watch the world go by
jagman
  • jagman
  • 50.2% (Neutral)
  • Newbie Topic Starter
17 years ago
"simonrl" wrote:

Sounds fun, shall I bring the drill?

We've got those 20mm drill bits as well...





Mmmmh πŸ˜‰
Next time one of you is in Cwmorthin could you measure the diameter of all those steel pegs that were part of the power station contribution?
If they aren't suitable there is loads of re-bar too.
simonrl
  • simonrl
  • 51% (Neutral)
  • Administration
17 years ago
Will do :thumbsup:
my orders are to sit here and watch the world go by
jagman
  • jagman
  • 50.2% (Neutral)
  • Newbie Topic Starter
17 years ago
"simonrl" wrote:

Will do :thumbsup:



Good man πŸ˜‰
Perhaps an estimate of tha gap we are going to try and span too? that way we can organise some planks (of some description) and chain/rope

Far more in favour of these old semi-suicidal methods than certain death on a SRT rope πŸ˜‰
Or at least I am until we have tried it.....
simonrl
  • simonrl
  • 51% (Neutral)
  • Administration
17 years ago
"jagman" wrote:

Perhaps an estimate of tha gap we are going to try and span too? that way we can organise some planks (of some description) and chain/rope



Eeek, I'm not right good at estimating distances from these photos; I tend to take them all on F2.8 which foreshortens them somewhat...

Something between not very far and quite a long way ;)

Perhaps 50 to 60 feet maybe? Will make a note to have a proper look next time.

There's almost certainly nothing to see on the other side, G floor continues in the western direction for a few more chambers; but as an exercise in catwalk building...
my orders are to sit here and watch the world go by

Disclaimer: Mine exploring can be quite dangerous, but then again it can be alright, it all depends on the weather. Please read the proper disclaimer.
© 2005 to 2023 AditNow.co.uk

Dedicated to the memory of Freda Lowe, who believed this was worth saving...